Zoom In

At the heart of the unique DesignTek air filter is a specially developed polyurethane foam which acts as a filtration medium, higher both higher performance and life expectancy then paper air filters. The PYRAMID VORTEX design outer surface area will absorb larger amounts of airborne dirt particles, while still allowing air to flow freely.
High flow with excellent filteration.

This Product Fits:

Porsche 911 (996) 3.4 Carrera (301bhp) 06/97 - 10/01
Porsche 911 (996) 3.4 Carrera, Carrera 4 (320bhp) 06/99 -
Porsche 911 (996) 3.6 Carrera, Carrera 4, 4S (320bhp) 09/01 -
Porsche 911 (996) 3.6 Carrera, Carrera 4 (345bhp) 05/02 -
Porsche 911 (997) 3.6 Carrera 07/04 -
Porsche 911 (997) 3.8 Carrera S 07/04 -

Zoom In

The 997 marked Porsche's return to the round headlights and curvaceous fenders reminiscent of the 993 and earlier era Carreras. Although the 997's picturesque styling is another milestone in Porsche design history there is still room for improvement in the engine performance department.

The IPD "Y" design plenum replaces the factory "T" style air distributor and provides substantial power and torque gains by means of a more efficient design. Horsepower gains range from 24 to 28 depending on engine displacement and engine condition. These max power gains are experienced in the mid range where is it most useable and enjoyed.

The IPD plenum not only delivers impressive power and torque increases but also creates a more linear power and torque band. Tiptronic customers even claim considerable improvements with more positive shifting after installing the IPD Plenums.

The 997S IPD Plenum provide power increases throughout the entire power band. Gains of 28 horsepower and 26 foot pounds of torque are experienced in the midrange with gains of 11 to 12 hp at the peak.

The "Y" design of the 3.8 liter IPD Plenum also allows for a more linear power delivery and improved throttle response that elevates the 997 S Carrera driving experience even higher.

Power improvements will be fully realized once the factory DME makes all the necessary “adaptation” requirements which occurs after a series of hard pulls on the dyno or full throttle runs (at your local race track of course).

The 997S IPD Plenum is a direct bolt on replacement and installation is relatively straight forward for mechanically inclined DIY customers although IPD strongly recommends all Plenum installations be performed by a trained and qualified Porsche technician.

Fits:
Porsche 997 GEN1 3.8L S

Zoom In

Recharger Filter Care Service Kit (aerosol)

A six-step maintenance system designed to clean any K&N Filtercharger® Air Filter.

Restores air flow efficiency so your Filtercharger performs like new!

Includes:
6.5 oz. Spray Oil & 12 oz. Filter Cleaner

Please note this item can not be sent out by plane. Deliveries only to European countries by road service

Zoom In

Engineered for maximum power and sound. This engineered system eliminates the OEM restrictive airbox and incorporates a high flow cone air filter and sealed fresh air chamber. A cone filter has superior air flow characteristics as compared to flat panel filters. The cone filter better shapes the air as it enters through the filter for smoother straighter more formed air. Next, we have CMC machined a MAF housing to the exact tolerances of the OEM housing for precise MAF reading and NO CHECK ENGINE LIGHTS. In addition, the sealed air chamber sections off the cone air filter from the engine compartment so that it can only draw cool outside air for more power. Finally, the system is injected molded from crosslink polyethylene which has the lowest thermal conductivity rating of any single-layered moldable material available on the market today. This is key in keeping intake temperatures low and increasing power.

Fits: 997 2005>> C2 /C2S /C4 /C4S

Zoom In

K&N High Performance replacement air filter.
- High Air Flow with Excellent Filtration

- Designed to Increase Horsepower and Acceleration Washable and Reusable

- Lasts up to 50,000 miles before cleaning is required depending on driving conditions

- Works with Original Equipment Manufacturer Vehicle Electronics

-Environmentally Friendly, K&N Reusable Air Filters

This Product Fits:


Porsche 911 (996) 3.4L Carrera (301bhp) 06/1997-10/2001
Porsche 911 (996) 3.4L Carrera, Carrera 4 (320bhp) 06/1999>>
Porsche 911 (996) 3.6L Carrera, Carrera 4, 4S (320bhp) 09/2001>>
Porsche 911 (996) 3.6L Carrera, Carrera 4 (345bhp) 05/2002>>

Porsche 911 (997) 3.6L Carrera 07/2004>>
Porsche 911 (997) 3.8L Carrera S 07/2004>>

BMC air filters are designed and produced to ensure a higher air flow than original paper filters. In F1, for example, BMC cotton filters minimize the loss of air flow pressure passing through the air filter; this way ensures the best conditions for full exploitation of maximum power. Therefore the benefits of replacing the original paper filter with BMC cotton air filter, produced using the same technology and materials as the F1 air filters, are evident.

DESIGN AND MATERIALS
Qualified engineers using advanced software and expert technicians using the latest technologies produce BMC air filters. An F1 filter must be very light, must be made of the best raw materials and must improve performance. For this reason we use only alloy mesh with epoxy coating to ensure protection from petrol fumes and from oxidization due to the humidity of the air. The filtering material is composed of a special cotton gauze soaked with low-viscosity oil to give you the best air permeability.


This Product Fits:


Porsche 911 (996) 3.4 Carrera 2/4
Porsche 911 (996) 3.6 Carrera 2/4
Porsche 911 (997) 3.6 Carrera 2/4
Porsche 911 (997) 3.8 Carrera 2S /4S

Panel Filter Size:
- width - 171/128mm
- height - 3528mm

Designed to give 25% more air flow, which in turn gives more power.

Installing the cold air performance enhancement kit will make any standard 997 with factory mufflers sound as if you have added a very mild performance exhaust. This is perfect for any 997 owner that wants his car to sound slightly more aggressive than stock.

The cold air kit adds 1.5 liters of cold air by eliminating the plastic factory muffler in air pipe, this allows the engine to draw cold air across entire topside of air box (left and right rather than just from the right) Adds 0.42 seconds faster acceleration 3000-6000 RPM.

The cold air kit is made from 4 ply silicone tube - better flow from air box to throttle body.

No “Check engine” lights as you retain the factory MAF.

Kit Contains:
1 x Cold Air Hose
2 x Jubilee Clips
1 x Alloy Stopper plug

*Please add a K&N / BMC or DesignTek air filter with this kit as it is not included