Jacking Beams
• Model No. SJBEXLP100A• 100mm Extension adaptor for use with 2tonne Low Profile Jacking Beam - Model No. SJBEX200LP.100mm Extension Lift Adaptor (Pair)
• Model No. SJBEXLPFLA• Spring loaded flat arms with roller bearings for use with 2tonne Low Profile Jacking Beam - Model No. SJBEX200LP.Flat Arm Set - Spring Loaded
• Low profile design permits use on lifts mounted in pits and commonly used in ATLs.
• Also permits use on vehicles with low ground clearance.
• Fitted with large diameter roller support arms for use on lifts with inner rail type configuration.
• Ultra wide configuration arms extend to 1.65mtr and feature adjustable saddles with interchangeable height posts (optional).
• Tried and tested hydraulic system with double stroke pump and two-stage mechanical safety lock for added safety.
• Model No. SJBEX200LP• Low profile design permits use on lifts mounted in pits and commonly used in ATLs.
• Also permits use on vehicles with low ground clearance.
• Fitted with large diameter roller support arms for use on lifts with inner rail type configuration.
• Ultra wide configuration arms extend to 1.6mtr and feature adjustable saddles with interchangeable height posts (optional).
• Tried and tested hydraulic system with double stroke pump and two-stage mechanical safety lock for added safety.2tonne Wide Arm Low Profile Jacking Beam
• 1.6mtr Load arm reach.
• Beam Lift: 95-300mm.
• Two-stage mechanical safety lock and telescopic finger guards.
• Spring loaded flat arms with roller bearings.
• Optional hook arms supplied.
• Supplied with two pairs of aluminium support blocks.
• Wide lift configuration meets VOSA recommendation for lifting on jacking point.
• Model No. SJBEX300• 3tonne Capacity and fully certified and approved to comply with VOSA requirements.
• Features two-stage mechanical safety lock and telescopic finger guards to prevent accidental injury. Supplied with two pairs of aluminium support blocks.
• Beam has spring loaded flat arms with roller bearings - when unloaded, these support the weight of the beam, allowing the entire unit to run smoothly along the pit or ramp, but when loaded, they firmly stabilise the unit.
• Optional hook arms supplied.
• Wide lift configuration meets VOSA recommendation for lifting on jacking point.3tonne Jacking Beam with 1.6mtr Extending Arms & Flat Roller Supports
- Air Jacks
- Axle Stands
- Bottle Jacks
- Cranes
- Engine Stands & Supports
- Forklift, Farm & Tractor Jacks
- Load Handling
- Oil
- Ramps & Chocks
- Rotating Amber Beacons
- Scissor Jacks
- Tarpaulins
- Tow Poles & Ropes
- Towing Accessories
- Trailer Boards
- Transmission Jacks - Floor
- Transmission Jacks - Vertical
- Trolley Jacks
- Wheel Removal Trolleys
- Winches