Track Rods

Bump steer correcting tie rod kit.
Bump geometry correction. 1 kit, req'd per car.



For Porsche 993 1995-98 W/O RS Wheel Carriers

Lowered cars with non-RS wheel carriers suffer from bump steer and will benefit from bump geometry correction.

Bump steer is a change in toe due to vertical movement of the wheel, such as when driving over a bump. The toe change causes the car to turn, and the driver needs to constantly correct for this to maintain a steady trajectory. This makes the car a handful to drive, especially over bumpy road surfaces.

Bump correction is achieved by moving the tie rod end pivot about 10mm closer to the steering knuckle as compared to the stock tie rod end. This changes the angle of the tie rod to produce the bump geometry correction.

No Need To Convert Wheel Carriers

This Bump Steer Correcting Tie Rod kit provides bump geometry correction with the standard C2/C4 wheel carriers. It is not necessary to convert the wheel carriers to RS type to correct for bump steer when using our kit.

• Corrects for bump steer


• Eliminates rubber inner-joint


• Enhanced driving precision


• Easier and more cost effective than RS wheel carrier conversion

These Elephant Racing bump steer tie rods also eliminate the compliant rubber inner-joint found in the factory 964 tie rods with a spherical bearing providing a more direct and responsive steering feel. Thus, proper suspension geometry is restored, driver corrections are minimized, and vehicle trajectory is stabilized making driving control easier while reducing driver fatigue.

Out Performs All Other Tie Rods

Even on cars fresh from the Porsche factory assembly lines our anti-bump steer kit will reduce bump steer through the full range of motion.



相关参考编号
相关编号、被取代编号、交叉引用编号或替代编号，供比较之用。

2180018

您正在查看的产品与这些编号存在交叉引用关系

BBi 保时捷 RSR 风格外拉杆。
2 件套
使用我们的 BBI Porsche 964 993 RSR 型外拉杆，增强保时捷转向系统的操控性。这些外拉杆采用特氟龙内衬球形接头，与原装部件相比，可提供更好的反馈。不仅如此，它们还专门设计用于协助调整颠簸转向，使其成为峡谷雕刻和赛道爱好者的必备升级。

适合：
保时捷 993 1994-97

一体式外拉杆配有特氟隆内衬球形件，可提供比原装部件更好的反馈和更长的使用寿命。设计还有助于调整碰撞转向，是赛道爱好者的必备之物。

相关参考编号
相关编号、被取代编号、交叉引用编号或替代编号，供比较之用。

BBI99340100

您正在查看的产品与这些编号存在交叉引用关系

BBi Porsche RSR style inner tie rod.
Set of 2



Fits:
Porsche 964 1989-1994
Porsche 993 1994-97

These tie rods provide more consistent and firmer feedback without increase of NVH (noise, vibration and harshness)

These are a required upgrade for 964 owners looking to run our billet uprights

相关参考编号
相关编号、被取代编号、交叉引用编号或替代编号，供比较之用。

99334703105

您正在查看的产品与这些编号存在交叉引用关系

Steering track rod with ball joint.
Sold each.



Previous OE part numbers: 99334703102, 99334703103, 99334703104,

Fits:
Porsche 993 1994-97

The steering rack controls the front wheels by means of two track rods, terminated by replaceable joints - the "Track Rod Ends", attached to the swivel hubs. These will eventually wear, leading to problems with steering and handling, as well as being a failure point on the UK MOT and presumably on the statutory inspections in other countries.

Previous part numbers: 99334703103, 99334703104

相关参考编号
相关编号、被取代编号、交叉引用编号或替代编号，供比较之用。

99334703105

您正在查看的产品与这些编号存在交叉引用关系

Steering track rod with ball joint.
Sold each.



Previous part numbers: 99334703102, 99334703103, 99334703104

Fits:
Porsche 993 1994-97

The steering rack controls the front wheels by means of two track rods, terminated by replaceable joints - the "Track Rod Ends", attached to the swivel hubs. These will eventually wear, leading to problems with steering and handling, as well as being a failure point on the UK MOT and presumably on the statutory inspections in other countries.

相关参考编号
相关编号、被取代编号、交叉引用编号或替代编号，供比较之用。

99334703105

您正在查看的产品与这些编号存在交叉引用关系

Steering track rod with ball joint. Porsche 993 RS 1994-97
Sold each.



Previous part numbers: 99334703181, 99334703182,

Fits:
Porsche 993 RS 1994-97

The steering rack controls the front wheels by means of two track rods, terminated by replaceable joints - the "Track Rod Ends", attached to the swivel hubs. These will eventually wear, leading to problems with steering and handling, as well as being a failure point on the UK MOT and presumably on the statutory inspections in other countries.

相关参考编号
相关编号、被取代编号、交叉引用编号或替代编号，供比较之用。

99334703182

您正在查看的产品与这些编号存在交叉引用关系

Track Rod Inner Joint. Porsche 993 1994-97



Fits:
Porsche 993 1994-97

Click 'Zoom in' for large parts diagram.
Diagram Ref No 4.

Please note: Price is for each

相关参考编号
相关编号、被取代编号、交叉引用编号或替代编号，供比较之用。

99334713101

您正在查看的产品与这些编号存在交叉引用关系

Track rod inner joint



Fits:
Porsche 993 1994-97

The steering rack controls the front wheels by means of two track rods, terminated by replaceable joints - the "Track Rod Ends", attached to the swivel hubs. These will eventually wear, leading to problems with steering and handling, as well as being a failure point on the UK MOT and presumably on the statutory inspections in other countries.

Click 'Zoom in' for large parts diagram.
Diagram Ref No 4.

Please note: Price is for each

相关参考编号
相关编号、被取代编号、交叉引用编号或替代编号，供比较之用。

99334713101

您正在查看的产品与这些编号存在交叉引用关系

Track rod inner joint. Porsche 993 1994-97



Fits:
Porsche 993 1994-97

The steering rack controls the front wheels by means of two track rods, terminated by replaceable joints - the "Track Rod Ends", attached to the swivel hubs. These will eventually wear, leading to problems with steering and handling, as well as being a failure point on the UK MOT and presumably on the statutory inspections in other countries.

Click 'Zoom in' for large parts diagram.
Diagram Ref No 4.

Please note: Price is for each

相关参考编号
相关编号、被取代编号、交叉引用编号或替代编号，供比较之用。

99334713101

您正在查看的产品与这些编号存在交叉引用关系