支撑架
按品牌过滤
Front Strut Brace. Porsche 987 Boxster - Ultra Racing
代码: TW2-1860
Ultra Racing Front Strut Brace.
Specification: 2 Points
Fits:
Porsche 987 Boxster
Specification: 2 Points
Fits:
Porsche 987 Boxster
Please note: This product is a special order part and once ordered it cannot be cancelled or returned without our permission.
产品车辆组
- Porsche Boxster 987 2.7L 2005 -08/08
- Porsche Boxster 987 S 3.2/3.4L 2005-08/08
€149.06
当前 €146.08
缺货订单
Rennline Rear Subframe Stabilizer With Tie Downs (Rear). Porsche 986 Boxster / 987 Cayman / 987 Boxster
代码: E35SB96
Rennline Rear Subframe Stabilizer With Tie Downs (Rear).
Fits:
Porsche 986 Boxster
Porsche 987 Boxster
Porsche 987 Cayman
Most Boxster and Cayman owners who take their cars to the track, have equipped their Porsches with tires much wider and stickier than stock, which allows higher g-forces to be achieved in cornering and braking. During that type of hard driving, the 2 piece rear sub frame flexes with the extreme loads being put on them. This negates your car's finely tuned alignment settings, thereby reducing your braking and cornering potential, and increasing tire wear. With this install, your Porsche will handle and brake with greater precision, predictability, and feedback to the driver. Comes with integrated rear tie down brackets and hardware for a 10 minute installation. Also available as a set including front tie downs, or as just the rear tie down set without the stabilizer bar.
Note: Pictures may not show actual product.
Fits:
Porsche 986 Boxster
Porsche 987 Boxster
Porsche 987 Cayman
Most Boxster and Cayman owners who take their cars to the track, have equipped their Porsches with tires much wider and stickier than stock, which allows higher g-forces to be achieved in cornering and braking. During that type of hard driving, the 2 piece rear sub frame flexes with the extreme loads being put on them. This negates your car's finely tuned alignment settings, thereby reducing your braking and cornering potential, and increasing tire wear. With this install, your Porsche will handle and brake with greater precision, predictability, and feedback to the driver. Comes with integrated rear tie down brackets and hardware for a 10 minute installation. Also available as a set including front tie downs, or as just the rear tie down set without the stabilizer bar.
Note: Pictures may not show actual product.
产品车辆组
- Porsche Boxster 986 2.5L 1997-99
- Porsche Boxster 986 2.7L 1999-02
- Porsche Boxster S 986 3.2L 1999-02
- Porsche Boxster 986 2.7L 2003-04
- Porsche Boxster S 986 3.2L 2003-04
- Porsche Boxster 987 2.7L 2005 -08/08
- Porsche Boxster 987 S 3.2/3.4L 2005-08/08
- Porsche Boxster 987 MKII 2.9L 2009-2012
- Porsche Boxster S 987 MKII 3.4L 2009-2012
- Porsche Cayman 2.7L 987C 2006-08
- Porsche Cayman S 3.4L 987C 2005-08
- Porsche Cayman 2.9L 987C MKII 2009-12
- Porsche Cayman S / R 3.4L 987C MKII 2009-12
€295.12
当前 €289.22
库存
Rennline Strut tower brace - 2 point. Porsche 997/987/Cayman
代码: SB63SILVER
Rennline Strut tower brace - 2 point. FRONT.
Fits:
Porsche 997 2005>>
Porsche 987 Boxster 2005>>
Porsche 987 Cayman 2005>>
One of the easiest and most cost-effective ways to improve your car's handling is the installation of a Rennline strut tower brace. These braces bridge both shock towers, eliminating virtually all camber change that occurs during hard cornering. Not all cars are the same, so Rennline has made their braces fully adjustable, allowing you to set a desired amount of pre-stress. Both the strut bar and brackets are constructed from aircraft grade aluminum, and include stainless steel hardware. Rennline strut tower braces bolt in and out in minutes and require no drilling. Whether you're on the street or on the track you'll feel the difference immediately. This strut brace does allow the use of your plastic cowl cover but small alteration would be required.
Please note some cars might require the ends of the brace cut by approx 10mm each side in order to fit the bar on towers. This might be depending on the location of your top mounts.
Note: Pictures may not show actual product.
Fits:
Porsche 997 2005>>
Porsche 987 Boxster 2005>>
Porsche 987 Cayman 2005>>
One of the easiest and most cost-effective ways to improve your car's handling is the installation of a Rennline strut tower brace. These braces bridge both shock towers, eliminating virtually all camber change that occurs during hard cornering. Not all cars are the same, so Rennline has made their braces fully adjustable, allowing you to set a desired amount of pre-stress. Both the strut bar and brackets are constructed from aircraft grade aluminum, and include stainless steel hardware. Rennline strut tower braces bolt in and out in minutes and require no drilling. Whether you're on the street or on the track you'll feel the difference immediately. This strut brace does allow the use of your plastic cowl cover but small alteration would be required.
Please note some cars might require the ends of the brace cut by approx 10mm each side in order to fit the bar on towers. This might be depending on the location of your top mounts.
Note: Pictures may not show actual product.
产品车辆组
- Porsche Boxster 987 2.7L 2005 -08/08
- Porsche Boxster 987 S 3.2/3.4L 2005-08/08
- Porsche Boxster 987 MKII 2.9L 2009-2012
- Porsche Boxster S 987 MKII 3.4L 2009-2012
- Porsche 997 Carrera 2 3.6L 2005>>
- Porsche 997 Carrera 2S 3.8L 2005>>
- Porsche 997 Carrera 4 3.6L 2005>>
- Porsche 997 Carrera 4S 3.8L 2005>>
- Porsche 997 TURBO 2007>>
- Porsche 997 GT3 2007>>
- Porsche 997 GT2 2007>>
- Porsche 997 MKII Carrera C2 3.6L 2009>>
- Porsche 997 MKII Carrera C4 3.6L 2009>>
- Porsche 997 MKII Carrera C2S 3.8L 2009>>
- Porsche 997 MKII Carrera C4S 3.8L 2009>>
- Porsche 997 MKII GT3 2010>>
- Porsche 997 MKII Turbo 2009>>
- Porsche 997 MKII GT2 RS 2011>>
- Porsche Cayman 2.7L 987C 2006-08
- Porsche Cayman S 3.4L 987C 2005-08
- Porsche Cayman 2.9L 987C MKII 2009-12
- Porsche Cayman S / R 3.4L 987C MKII 2009-12
€368.90
当前 €361.52
库存
STRUT BRACE BAR for Porsche 997 / 987 / Cayman FRONT DesignTek
代码: 360210997
DesignTek Front Strut Braces Finished in light weight but very strong alloy. Chassis stiffening devices adapt to the OEM strut mounts and helps to reduce chassis flex for better cornering and more precise handling on the street or track. This suspension upgrade is a must for any street or track driven. Increase your driving experience and become one with the road.
Fits:
Porsche 997 / 997S
Porsche 987 Boxster
Porsche 987C Cayman
Fits:
Porsche 997 / 997S
Porsche 987 Boxster
Porsche 987C Cayman
产品车辆组
- Porsche Boxster 987 2.7L 2005 -08/08
- Porsche Boxster 987 S 3.2/3.4L 2005-08/08
- Porsche 997 Carrera 2 3.6L 2005>>
- Porsche 997 Carrera 2S 3.8L 2005>>
- Porsche 997 Carrera 4 3.6L 2005>>
- Porsche 997 Carrera 4S 3.8L 2005>>
- Porsche 997 TURBO 2007>>
- Porsche 997 GT3 2007>>
- Porsche Cayman 2.7L 987C 2006-08
- Porsche Cayman S 3.4L 987C 2005-08
价格低至: €145.77
显示从1到4(共4个产品)
关于支撑架
底盘加固装置可适应 OEM 支柱支架,有助于减少底盘弯曲,从而实现更好的转弯和更精确的街道或赛道操控。这种悬架升级对于任何街道或赛道驾驶的汽车来说都是必备的 - 提高您的驾驶体验
您可能也喜欢
- 防侧翻稳定杆
- 运动弹簧
- 前控制臂
- 后控制臂
- 前悬挂连接杆
- 后悬挂连接杆
- 发动机支架
- 变速箱座
- 前侧车顶支架
- 后侧车顶支架
- 转向横拉杆
- 气动升降系统
- 悬架控制单元
- Bilstein B4 标准替换件
- Bilstein B4(带 PASM 按钮的车辆)
- Bilstein SPORT B6 减震器
- Bilstein SPORT B6(带 PASM 按钮的车辆)
- Bilstein SPRINT B8 减震器
- Bilstein SPRINT B8(带 PASM 按钮的车辆)
- Bilstein B12 调校悬架套件
- Bilstein B14 PSS 避震悬架套件
- Bilstein B16 PSS9/10 高度减震可调避震悬架套件
- Bilstein B16 DampTronic (PASM)
- Bilstein EVO SE
- Ohlins 道路及赛道悬架
- Koni 运动系列
- Koni Special Active 系列
- Powerflex 聚氨酯衬套
- Powerflex 黑色系列衬套
- H&R 可调悬架套件
- H&R Cup-Kit 系列运动悬架
- KW 变体 1 Inox 悬架套件
- KW 变体 2 Inox 可调回弹减震悬架
- KW 变体 3 Inox 可调悬架套件
- KW Clubsport 避震悬架套件
- KW Clubsport 避震悬架套件(带车顶支架)
- Sachs 高性能悬架 CSS
- Nitron 汽车系列
流行车型