Air Induction Kits

BMC Air Filter



This Product Fits:
Porsche 911 3.3L Turbo 1977-89
Porsche 964 3.3L Turbo >>1993

Panel Filter Size:
- width - 210mm
- height - 344mm


BMC air filters are designed and produced to ensure a higher air flow than original paper filters. In F1, for example, BMC cotton filters minimize the loss of air flow pressure passing through the air filter; this way ensures the best conditions for full exploitation of maximum power. Therefore the benefits of replacing the original paper filter with BMC cotton air filter, produced using the same technology and materials as the F1 air filters, are evident.

DESIGN AND MATERIALS
Qualified engineers using advanced software and expert technicians using the latest technologies produce BMC air filters. An F1 filter must be very light, must be made of the best raw materials and must improve performance. For this reason we use only alloy mesh with epoxy coating to ensure protection from petrol fumes and from oxidization due to the humidity of the air. The filtering material is composed of a special cotton gauze soaked with low-viscosity oil to give you the best air permeability.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

FB437

The product you are viewing cross references to these numbers

Distributor Vent Kit.

964 Ventilation Kit includes:
- Distributor ventilation connection (A)
- Rubber Grommet (B)
- White Grommet connector (C)
- Hose (D)

HOW TO FIT: Firstly prise of the oval plate arrowed on the distributor with a screwdriver. Then remove the large black air guide pipe as we need to drill a hole in it at the green dot. The pipe removes by loosening jubilee clips at top and bottom. You will also need to remove two sensor connectors on the pipe. I also removed the two sensors near the distributor so that I had easy access to the plate. Drill at 18mm hole in the pipe, 40mm to the right of the tail light ventilation nipple. Deburr the hole and remove all shavings. Install the rubber grommet (B) into the hole and install the white connector (C) into the grommet.Install the distributor connector (A) into the hole in the distributor where the plate was. Finally refit the air pipe and connect back up all the sensors. Install the hose (D) onto the new distributor and air pipe nipples and route

Fits:
Porsche 964 1990-94
Porsche 993 1995-97

K&N High Performance replacement air filter.



This Product Fits:
Porsche 911 (930) Turbo 3.0L 1975-77
Porsche 911 (930) Turbo 3.2L 1977-90
Porsche 965 Turbo 3.3L 1990-93
Porsche 965 Turbo 3.6L 1993


K&N® washable, reusable High-Flow Air Filters™ feature a state-of-the-art design of layered, oiled cotton media engineered to improve airflow and capture contaminants, and are designed to provide an increase in horsepower.

Each performance air filter is reusable, engineered to last for the entire lifespan of your vehicle, and backed by K&N's 10-Year/Million Mile Limited Warranty.

K&N drop-in replacement filters are designed to install easily into your factory air box.

Works with Original Equipment Manufacturer Vehicle Electronics.

Environmentally Friendly, K&N Reusable Air Filters

Upgrade today and start enjoying superior airflow and superior performance from K&N's most popular product!

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

33-2530

The product you are viewing cross references to these numbers