Cardan prop shaft support bearing repair. Porsche Cayenne 955 / 957 Most models

Porsche Cayenne Drive Shaft Clamping Bearing Support Mount The ONLY device that can be installed without removing the Drive Shaft from the vehicle



NEW DESIGN, BOLTS NO LONGER SUPPLIED , PLEASE USE EXISTING HARDWARE

Best Selling Product

The innovative Drive Shaft Clamping Center Support (DSCCS) by is the only true Permanent fix to premature bearing support failures. This Patent-Pending device was developed by our team of technicians whom over the course of 2 years were able to create what is now the end-all solution to failing Bearing Supports.
The Clamping Center Support is the ONLY device that can be installed without removing the Drive Shaft from the vehicle or without requiring the disassembly of the Drive Shaft. Why is this so important?
1) By not having to disassemble the Drive Shaft means that NO re-balancing of the shaft is required. All other methods of Bearing Support replacement require this expensive and lengthy procedure. Failure to balance the once disassembled Drive Shaft would result in major vibrations.
2) Our Clamping Bearing Support installs easily to your Drive Shaft, using basic household tools, in less than an hour. This is a Do-it-Yourself repair that will save you very costly repair bills and unnecessary time down. Should you choose to have a professional install it, the labor times will be much less than Drive Shaft replacement or any other method of repair.
The cause of the premature Drive Shaft Support failure is a direct result of too much continuous stress imposed upon the rubber in the mount. This is more the product of the Drive Shaft design than the quality of the rubber material in the mount. Unfortunately, by merely replacing the Bearing Support with another similar rubber mount you can expect much of the same results experienced with the factory rubber mount.

There is only One certain and definite fix.
The EPS Drive Shaft Clamping Center Support for the Porsche Cayenne, Volkswagen Touareg & Audi Q7 takes a completely different approach in solving this, all too common, problem. Getting away from the proven failure-prone solid rubber vibration dampener, we instead use multiple, hollow Silicone Pods. This design is much better equipped to withstand the constant compressing and stretching forces generated while in use. The silicone material also does a much better job of handling the heat and atmospheric conditions located under your vehicle. Even better, although we have over Two Years of use on our test vehicle and the DSCCS is still functioning flawlessly, in the rare event that any of the Pods on the DSCCS fail, they are very easily replaced in minutes.
Key Benefits

� Permanently repairs the notorious bearing support
� DIY installation - typically in under one hour using household tools
No need to remove or disassemble your current Drive Shaft
No need to re-balance your Drive Shaft
No need to send in your faulty Drive Shaft
No core charges
Patent-Pending design
Will pay for itself in labor & shipping costs

*Warranty void if front flex disc is not replaced when the Drive Shaft Clamping Bearing Support Mount is installed.

Fits:
Porsche Cayenne 955 V6 3.2L MK I 2003-2006
Porsche Cayenne 955 V8 S 4.5L MK I 2003-2006
Porsche Cayenne 955 V8 4.5L Turbo MK I 2003-2006

Porsche Cayenne 957 6cyl 3.0L MK II 2007-2008
Porsche Cayenne 957 V8 3.6L MK II 2007-2008
Porsche Cayenne 957 V8 4.8L MK II 2007-2008
Porsche Cayenne 957 V8 4.8L GTS MK II 2007-2008
Porsche Cayenne 957 V8 4.8L Turbo MK II 2007-2008




Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

95542102098

The product you are viewing cross references to these numbers