Oxygen Sensor Extension Oxygen Sensor Extension with built in additional cat for Porsche 90 Degree Angle

Fabspeed Universal 90 Degree O2 spacers with catalytic converters



Product Details:
Universal O2 Spacers with Catalytic Converters scrub the exhaust and lengthen the distance between the O2 sensor(s) and the exhaust flow to reduce the chance of a CEL.

We've taken our O2 spacers a step further. The factory ECU compares the readings from a pair of oxygen sensors to measure the effectiveness of the catalysts. When a high-flow cat or catbypass pipe is used the exhaust gases reach the O2 sensor faster and uncleaned, leading to high chances to throw a CEL. Our O2 spacers retract the secondary oxygen sensors from the direct flow of gases, restoring the balance that the ECU requires when using aftermarket catalysts or catbypass pipes. The high quality built in catalysts scrub the exhaust to further reduce the chance of a CEL. Two fitting options and the two piece design allow for adjustment to get best possible fitment and results.

FEATURES:
Fits most makes & models worldwide
Compatible with all Fabspeed Motorsport header, Sport Cat, and Catbypass products
Minimizes the triggering of the CEL by moving the O2 sensor further from the exhaust stream and scrubbing exhaust
Male end threads into existing M18 x 1.5 O2 Bungs
Spacer body dimensions: 3 3/4" L x 1 1/2" W x 1 1/2" H
Fitting dimensions: 1" L x 1" W x 1" H (not including threaded portion)
1" depth of threads on fittings for adjustments

IMPORTANT NOTES:
For use on downstream oxygen sensors only
This product cannot guarantee emissions compliance
Universal fitment

Fabspeed Universal 45 Degree O2 spacers with catalytic converters, Pair.



Product Details:

There is no guarantee this will prevent a CEL from triggering

Universal O2 spacers with real precious metal Catalytic Converters lengthen the distance between the O2 spacer(s). We've taken our spacers a step further by having built-in catalytic converters to allow the ECU to properly read exhaust gas and perform at optimal performance.

Oxygen sensors can occasionally trigger a CEL on stock vehicles due to the new advances of technology and would require an O2 spacer to bring the vehicle back to equilibrium and allow the ECU to read exhaust gases within the proper threshold.

FEATURES:

• Fits most makes & models worldwide (Specify Angle option from drop down above and Quantity needed for your specific vehicle)
• Spacer available in a 90 Degree
• Male end threads into existing M18 x 1.5 O2 Bungs
• Spacer body dimensions: 3 3/4" L x 1 1/2" W x 1 1/2" H
• Fitting dimensions: 1" L x 1" W x 1" H (not including threaded portion)
• 1" depth of threads on fittings for adjustments

Read about MotoIQ's 987.2 Cayman S track build that used these O2 Spacers

NOTES:

• For use on DOWNSTREAM oxygen sensors only
Universal fitment for all cars
• For off road competition use only, not to be use on public roads or highways. Please check with your local authorities to ensure compliance with all laws.
• There is no guarantee this will prevent a CEL from triggering, please contact a Fabspeed Performance Specialist for more details.

PURCHASE DISCLAIMER: Fabspeed Motorsport does not condone the use of emission defeat devices for any vehicles used on public streets or roadways. Fabspeed Motorsport will not tamper, remove, disable, or bypass emissions equipment on a motor vehicle in accordance with 40 CFR Section 86.1854.12(a)(3), Clean Air Act 40 CFR 1068.101(b). This includes software, known as tunes, that reprogram a motor vehicles electronic control module to alter engine performance and enable the removal of filters, catalysts, and other critical emissions controls.