Fits:
Porsche 911 - 1974 to 1989
When removing the radio, it was impossible to find a replacement cubby that fit perfectly, maximized the space, and looked like it was meant to be there. All aftermarket cubbies were either too thin, poorly fitting, or impossible to mount, and none of them had a well-finished surround trim.
Now offering this radio delete cubby pocket to anyone who wants to utilise the space for more storage instead of using available block-off plates. The pocket is made from PA12 nylon, making it very durable and resistant to heat, chemicals, and wear. The finish texture resembles typical car plastic parts.
Inside dimensions of the pocket:
Width: 177mm / 6.95"
Height: 44mm / 1.73"
Depth: 102mm / 4" (deep enough to hold a phone but not too deep to make it hard to pull items out)
Installation involves sliding the pocket into the opening, then sliding four retaining blocks (three on the bottom, one on the top) from the back of the pocket into the guides. These blocks securely attach the pocket against the metal dash. After the blocks are in place, use a thin needle or nail to align the nuts inside the blocks with the holes in the pocket. Finally, fasten everything with seven screws (this needs to be done inside the pocket, so it’s best to use a Phillips head screwdriver attachment; finger tight should be enough—do not over-tighten).
Included:
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
91155246302
The product you are viewing cross references to these numbers
- Porsche 911 1984-1986 3.2L
- Porsche 911 1987-1989 3.2L G50
- Porsche 911 1978-1989 3.3L Turbo (930)