Fits:
Porsche 911 / 912 / 930 All
If you have never changed your lower steering column bearing that's located in the smuggler's box, there's a good chance that the bearing inside the rubber housing is non-existent. This bearing helps to prevent slop in the steering linkage assembly, but over time, the needle bearing inside gets corroded and ultimately disintegrates. This is often mis-diagnosed as a bad tie rod end because effect on the steering response is very similar. Rennline has created a billet aluminum housing the includes a pressed in needle bearing and unlike the factory unit, this one includes two weather seals to protect the bearing.
Replace it once and don't worry about it again.
- Porsche 911 1965-1968 2.0L / 912 SWB (F)
- Porsche 911 1968-1973 2.2L / 2.4L / 2.7L RS LWB (F)
- Porsche 911 1974-1977 2.7L / 1976-77 3.0 Carrera
- Porsche 911 1978-1983 3.0L / SC
- Porsche 911 1984-1986 3.2L
- Porsche 911 1987-1989 3.2L G50
- Porsche 911 1975-1977 3.0L Turbo (930)
- Porsche 911 1978-1989 3.3L Turbo (930)