Manufactured to the very highest standards of quality and safety. Fully certified to EN 60900 IEC 900 standard.
• At a temperature of -20ºC the handles must withstand impact and shock loads.
• After 24 hours immersion in water, the pliers must still provide protection against discharges and spark-over at up to 10,000V AC.
• After 2 hours at +70ºC, the pliers must not conduct discharge at a test of 5,000V AC even with a point load of 20N applied.
• After 168 hours (1 week) at +70ºC, the handles must still be firmly secured to the pliers and be able to withstand a 500N pull-off test.
• The handles must be manufactured from near inflammable materials. This is tested using a gas flame.
• All pliers are manufactured from high grade tool steel and are hardened using a special high frequency induction process. Cutting capacities quoted according to DIN/ISO 5744.• VDE Approved.
• Induction hardened cutting edges.
• Soft grip handles for comfort and control.
• Cutting Capacity: Ø1.6mm.
• Meets DIN 5236/ISO 5748.
• Model No. AK83512• VDE Approved long nose pliers with induction hardened cutters in a polished finish.
• Supplied with soft grip handles for comfort and control.
• Wire cutting capacities quoted according to DIN 5236/ISO 5748.160mm Long Nose Pliers - VDE Approved